Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might find that your garage door opener has been giving you issues, so you require to fix it. You can fix it by replacing a circuit card, a photo-eye sensing unit, the major drive gear, or the set-limit buttons. You can likewise check if the security sensors are functioning correctly.

Replacing a motherboard

Replacing a circuit board for your garage door opener calls for a couple of steps as well as devices. First, you need to turn off the circuit breaker and disconnect any kind of cords. Next off, open up the circuit board cover. This will help you to detect the problem and also identify if you need a brand-new board. Next, get rid of the old board and its cord adapters.

You can after that continue to change the circuit card. The substitute process is very easy and also takes about 10 mins. A new circuit board will cost about $80. To safeguard your brand-new circuit board from power surges, you can buy a surge guard.

Changing a photo-eye sensing unit

Replacing a photo-eye sensing unit can be a relatively easy job. Initially, get rid of the sensing unit from the door and also make certain it is located correctly. If the sensing unit is angled at all, it might not be receiving the appropriate signal, which can be triggering the strobe lights. If you see that the photo-eyes run out positioning, you may need to have a professional come and also take care of the trouble.

The photo-eye sensing unit consists of two items that mount outside of the door tracks and also towards the flooring. The picture eyes will have a little LED light and must be strong in color. If the light is blinking, its most likely the photo-eye is malfunctioning and also will need to be changed.

Changing a main drive gear

To replace a garage door opener primary drive equipment, begin by getting rid of the cap from the chain wheel. Next, remove both screws holding the drive gear to the sprocket assembly. Now, you can loosen the 3 stress pins. Squeeze them from both sides and after that remove them. After that, separate the three wires from the garage door opener electric motor. These cords need to be white, red, and blue.

As soon as you have removed the old equipment, set up a brand-new one. Make sure to grease it well. Put the brand-new equipment right into the shaft, seeing to it to line up the placing holes. See to it the gear as well as sprocket setting up are positioned properly to guarantee smooth procedure. Next, use a hammer as well as a nail to drive a pin right into the brand-new equipment.

Adjusting the set-limit buttons

The first thing you need to do if your garage door is not functioning appropriately is to inspect the set-limit buttons. You may require to readjust them to make sure that the door shuts earlier or stops before it gets to the floor. You can examine this by considering your garage doors guidebook or online.

To adjust the set-limit switches, youll require a screwdriver or socket. Readjust the knob clockwise or counterclockwise till the door moves up as well as quits, or reduces its range. To check for appropriate travel distance, determine the space from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488