Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may discover that your garage door opener has actually been offering you issues, so you require to repair it. You can fix it by replacing a circuit board, a photo-eye sensor, the primary drive gear, or the set-limit switches. You can additionally inspect if the security sensing units are functioning properly.

Changing a motherboard

Changing a circuit card for your garage door opener needs a couple of steps and also devices. First, you need to shut off the circuit breaker and disconnect any kind of cords. Next off, open up the motherboard cover. This will help you to detect the trouble and also figure out if you need a brand-new board. Next, remove the old board and its cord connectors.

You can after that continue to replace the circuit card. The replacement process is simple as well as takes about 10 minutes. A brand-new circuit card will certainly set you back about $80. To protect your brand-new circuit card from power rises, you can acquire a surge guard.

Replacing a photo-eye sensing unit

Replacing a photo-eye sensor can be a fairly basic job. Initially, get rid of the sensing unit from the door as well as ensure it is positioned properly. If the sensor is angled in any way, it may not be obtaining the right signal, which could be triggering the strobe lights. If you observe that the photo-eyes run out positioning, you may need to have actually a service technician come and deal with the trouble.

The photo-eye sensing unit contains two pieces that place outside of the door tracks and also towards the flooring. The photo eyes will have a tiny LED light and also need to be solid in color. If the light is blinking, its likely the photo-eye is defective and also will certainly require to be replaced.

Replacing a primary drive gear

To change a garage door opener main drive equipment, begin by getting rid of the cap from the chain pulley. Next, get rid of both screws holding the drive gear to the gear assembly. Now, you can unfasten the 3 tension pins. Squeeze them from both sides and afterwards eliminate them. Then, disconnect the three cords from the garage door opener motor. These cords ought to be white, red, as well as blue.

As soon as you have actually gotten rid of the old gear, install a brand-new one. Be sure to oil it well. Place the brand-new gear right into the shaft, seeing to it to align the placing openings. Ensure the equipment as well as sprocket setting up are located correctly to guarantee smooth operation. Next off, use a hammer as well as a nail to drive a pin into the new gear.

Changing the set-limit buttons

The first thing you need to do if your garage door is not working properly is to inspect the set-limit switches. You may require to readjust them so that the door shuts earlier or quits before it gets to the flooring. You can check this by looking at your garage doors manual or online.

To readjust the set-limit switches, youll need a screwdriver or outlet. Change the knob clockwise or counterclockwise till the door moves up and also quits, or reduces its range. To look for correct traveling distance, determine the void from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Back To Top